Advanced Settings Tab

NOTE:

Your NOAHlink must be connected before you can use the Advanced Settings tab.

The Advanced Settings tab is used to set the following NOAHlink settings:

NOAHlink power off time: Select the length of idle time before NOAHlink turns off OR Select Off for it to remain on indefinitely.

HI power status:

Select On to turn on hearing instruments automatically when NOAHlink powers on.
Select Off for hearing instruments to be turned on through the fitting module.

Power on when leaving cradle: Select On for a previously powered on NOAHlink to power on automatically when removed from its cradle.

Driver: To change the driver, click Change. Select the driver after browsing for its location. Click OK.

COM Port Settings: (NOTE - Only select new values if your system CANNOT locate NOAHlink.) Use the pull-down menus at COM Port low and COM Port high to select new values.